Upload

1. If the device is off, power ON the device.
   • The power button is located at the bottom of the control box.
2. Navigate to the Upload menu.
3. The unit must be connected to a network to upload data. Go to Select Network.
4. On the Wifi Setup page, select Connect WiFi. If the device was previously connected to the network, select Use last AP.
5. Enter the network password.
   • Scroll through the characters by turning the rotary knob. To select the character in the middle of the screen, press down on the knob. 
   • Backspace: Hold down the rotary knob until the bar loads halfway on the top of the control panel, then release.
   • Enter: Hold the rotary knob down until the bar loads all the way on the top of the control panel, then release.
6. From the Upload menu, navigate to Upload.
7. Select Start to begin an upload.
   • The screen will display the number of files being uploaded, as well as its progress.
   • Do not turn the STRIKE unit off while an upload is in process.
   • The screen will return to the main menu after the upload is complete.

Note: After testing and uploading make sure to:

• Store the device in a safe location.
• Use the charging block and cable to plug the device in.
• Turn the device OFF.

For any upload questions, please submit a support request or email a STRIKE representative at [e-mail].