- Power ON the device.
- The power button is located at the bottom of the control box.
- Navigate to the Upload Menu.
- Navigate to Select Network.
- On the Wifi Setup page, select Connect WiFi. If the device was previously connected to the network, select Use last AP.
- Enter the network password.
- Scroll through the characters by turning the rotary knob. To select the character in the middle of the screen, press down on the knob.
- Backspace: Hold down the rotary knob until the bar loads halfway on the top of the control panel, then release.
- Enter: Hold the rotary knob down until the bar loads all the way on the top of the control panel, then release.
- From the Upload menu, navigate to Upload.
- Select Update Config.
- After downloading the new config, the device will return to the main menu.
-
Power your device OFF and then ON again.
- When the device powers on, it will read "Update Available" at the top of the screen.
-
Connect to your network again.
- To do this, navigate to the Upload menu, then Select Network, and Use last AP.
- Return to the main menu.
- Navigate to Settings.
-
Select Update Firmware.
- If the update was successful, you will see "Upgrade Successful!" at the top of the screen.
** Note, if you would like the option of using a Test field for non-test events (ie. becoming familiar with the device), please follow steps 1-9 to update the config a second time.
For any firmware update questions, please submit a support request or email a STRIKE representative at strike@biocorellc.com.